Installing Bullnose Corners

Installing Bullnose Corners

If your own home was built someday after the early 2000s, you might have observed it is missing sq. corners. Instead, most of your corners are rounded, or you will have bullnose baseboard corners. This rounded drywall nook gives properties a recent look without an excessive amount of trouble when drywalling.

But when you find yourself installing the baseboard round bullnose corners, things become more complicated. Not are you lining as much as forty five-degree corners (miters); putting in bullnose corner baseboard trim requires more precision.

Our Bullnose trim jig corner tool, the ¾’’ Bullnose Corner Gauge helps take the guesswork out of those additional steps. The flaps permit you to draw a line on both the wall and the baseboard piece you are cutting to make sure a perfect fit every time. Our guide for putting in these professional-trying baseboards for rounded corners with the ¾’’ Bullnose Trim Gauge, is below.

STEP 1: PREP YOUR BASEBOARD PIECES
Your baseboard pieces needs to be at least slightly longer than your wall sections. Measure your small items to the length of the corner they'll finish on, however then minimize with the extra board on the tip so that you can make your mark. Do this for each sides.

STEP 2: MAKE YOUR MARKS (MEASURE YOUR BASEBOARD)
Along with your trim prepped, take every bit and align it for marking. Mark each sides of the wall and every piece. Your wall line will now serve as a guide when fitting. You can double-check your mark with a tape measure, but if in case you have aligned everything square, that should be accurate.

STEP three: MAKE YOUR CUTS
With your pieces in hand, use your marks to make 22.5-degree cuts being careful to not minimize the mark (go away your mark visible after you chop). You’ll need these angled in to fit along with your heart-piece.

STEP 4: CUT YOUR CENTER PIECE
A key difference between the standard forty five-degree cuts and the rounded trim corners is the middle- piece. The piece will fit in between your minimize items to convey the nook together. These must be 5/eight’’ with two outward-facing 22.5-degree cuts.

STEP 5: FITTING
With your items in place, go back to your nook and dry-fit. Align the reduce on your size items to the mark on the wall to ensure they nonetheless match correctly.
Back to top
Back to top